Is the ignition coil cover on your Fox Body Mustang missing or damaged? Watch as Jmac shows you just how easy it is to replace your coil cover in this installation video. Installing a new cover will take you less than 15 minutes and best of all it is manufactured from the Ford Original Tooling! That means you get the ultimate in fit and finish!
Clean up your engine bay by hiding that mess of wiring around your Mustang ignition coil! You can pick one up in the link below. Don't forget to pick up a hardware kit and new performance ignition coil from MSD or Performance Distributors to finish off your installation!
Check out our YouTube channel for even more tech tips, installation videos, how-tos, and more. The best place to go for anything Mustang related!
Published on 2013-03-06 From the factory, Ford covered the Fox Body Mustang ignition coil. It hides the ignition coil and all the wiring around it. Not only did this protect the wires and coil from the elements but it made the engine look nice and neat by hiding this mess of wiring.
Often these are broken and cracked due to engine heat and weathering. The rest of the time they are missing because someone tossed them in order to show off an upgraded MSD or Screamin' Demon ignition coil.
Installation is super easy and should take you no more than 10 mins to remove the old one and install the new Mustang Coil Cover. If you are missing the installation hardware, LatemodelRestoration.com carries the 5.0Resto ignition coil cover hardware kit.
Transcript JONATHAN MCDONALD: Very commonly missing part on '86 to '93 Mustangs is the coil cover. Now this coil cover completely hides all the coil and the wiring that goes to the starter solenoid. Now our 5.0 Resto brand coil cover is identical to the original, has the correct mounting tabs, even has a notch cut out for the coil wire to pass through. Installation is extremely simple and will take you less than a minute. And it will greatly improve the appearance of your underhood.
Slide the coil cover down into place engaging the tabs on the bottom with the frame rail right above the display bar mount. Then line up your tabs and the middle one right behind the brake master cylinder on the strut tower. The top one with the hole right next to the fender-- use our 50resto push pin kit to attach the coil cover to the car and you're done.
All right, that literally took seconds to install and completely hides all the nasty wiring behind here. Now for more Mustang restoration and renewal parts, check out latemodelrestoration.com.
I live in Canada which makes getting parts more difficult due to shipping and availability. I decided to try late model restoration out as they are Canada shipping friendly. The order went smoothly and the parts arrived, and were exactly as i expected. Then a problem arose with one item. Now being in Canada this usually makes this a very painful experience to deal with due to the cost of shipping products back and forth across the border. Most of the time it is just easier and cheaper to just order a new one and cut the loses. Not in this case. I sent out an email with the issue and by the time I went outside to take a picture i already had a response. A new product was shipped out immediately. I could not believe how good the customer service was. This will be where i will get what i need for now on. Anyone can sell a product but it is nice to have a company stand behind what they sell. Thanks again.
these are mine and my Dads 2015 GT's. My Dad owns 2 other Mustangs a 1990 notch back and a 88 GT convertible. he has owned 8 Mustangs over time and over 230 cars in his lifetime. from Ford Model A's...