Video: Fox Body Mustang Cold Air Intake Installation (89-93 5.0 SVE)
Published on 2013-11-11
1989-93 FORD MUSTANG 5.0 SVE COLD AIR INTAKE KIT POLISHED - FOX BODY
Part Number # LRS-9659CA3K
Fits: Ford Mustang 5.0L - 1989 (89) - 1990 (90) - 1991 (91) - 1992 (92) - 1993 (93)
Are you looking to increase horsepower and fuel economy on your Fox Body Mustang? How about doing all of this without breaking the bank? Well you are in luck! The SVE Cold Air Intake for the 89-93 5.0L Mustangs will do all of this and even improve the looks of your underhood with its polished finish. Installation is super easy with the help of this how to installation video!
Each SVE intake includes all the needed hardware and components you need to replace the restrictive factory intake tube and box with this high flow SVE CAI. Don't forget to look at our SVE Power Packages that include the SVE intake and under drive pulley kit, 70mm throttle body and many other SVE performance parts. They are guaranteed to wake up any 5.0L HO push rod motor!! See our complete line of SVE performance packages here: http://www.latemodelrestoration.com/products/Mustang-Performance-Parts-Kits-1979-1993>Mustang Performance Part Kits
LatemodelRestoration.com, SVE & 5.0Resto are dedicated to the restoration and performance of your Project Foxbody Mustang!!
Improving the power output of your Fox Mustang 5.0 from '89 to '93 can be as economical and simple as installing one of our SVE cold air induction kits. Not only does it brighten up your underhood appearance, it improves your rear wheel horsepower. Installation takes mere minutes using common hand tools and is a direct replacement for your existing induction system. Follow along as we show you just how easy it is to install.
Unplug the mass air meter. Remove the two mass air bracket to strut tower bolts. Slide the mass air boot to air box clamp out of position. Loosen the air inlet tube clamp. Remove the mass air and inlet tube assembly from the vehicle.
Loosen the two clamps at the mass air and separate the mass air meter from the boot and tube. Remove the three bracket bolts from the bottom of the mass air. Remove the two air box retaining nuts. And then remove the air box from the car.
Remove the three air silencer retaining nuts. From underneath the fender, you can fully remove the air silencer from the car. Back up top, remove the two rubber insulators. Clean up the area if needed.
Slide the elbow tube through the fender plate and install the fender plate using the supplied hardware. Slide the boot with the lip in the middle of it on the end of the elbow tube. Slide two clamps into place.
Put the mass air in the boot. Slide the smaller boot on the other end of the mass air. Slide on two more clamps. Put on the remaining boot to the throttle body and two more clamps. Finally, install the inlet tube.
Making sure there's clearance at the strut tower and inlet tube, tighten all the clamps and reconnect the mass air meter. From underneath the fender, you can install the air filter onto the elbow tube and tighten the clamp.
See? That didn't take very long at all. You'll notice we did not use the bracket included with the kit. This is because, well, mainly my personal preference. I don't like putting them on, because sometimes it just makes things a lot more difficult. You can use yours if you desire. You can check out more SVE performance products for your Fox Mustang at latemodelrestoration.com.