Velocity Stack Air Inlet Guide Reduces Air Turbulence
Stainless Steel Housing & Shield
Lifetime Air Filter
Keeps Hot Air Out, Cold Air In
The 2010 Mustang GT's intake system from Ford is an excellent piece, but Steeda was up to the challenge of making it even better.
They started with a large surface area high flow air filter with their famous velocity stack. Then, they designed a stainless steel heat shield with rubber gasket to seal against the hood and increased the MAF housing size to 95mm then coupled it to a new higher flowing Pro-Flow inlet hose.
You would think this is more than enough, but Steeda went the extra mile and designed this intake system to accept the factory sound tube should you choose to want to keep it. They also have tied the airbox into the factory lower cold air scoop for the coolest air charge possible. Something other competitors on the market chose to neglect.
Airflow is increased so much that a tune is not just recommened, its required! Take a look at our SCT-3015 hand held tuner programmer to tune your Mustang.
If you already own a flash tuner, you may need to have a custom tune made for this cold air intake from your tuning supplier if it is not included on the device.
Typical gains with the 2010 Mustang GT Steeda Cold Air Kit and custom tune are 20 to 25 horsepower and up to 25 ft/lbs of torque. With proper tuning you will see extra power over the entire RPM range, not just a peak number.
Steeda - Everything Mustang
Latemodel Restoration Supply is proud to offer Steeda products for your Mustang or Lightning. Steeda Autosports is the #1 aftermarket company in Ford performance with performance Mustang, Focus & Truck parts. With 25 years under their belt, they are still one of the #1 aftermarket Mustang parts manufacturer in the industry. Their extensive research and development has produced top notch, high quality parts that get your Mustang or Lightning performing, handling, and looking better. Shop LatemodelRestoration.com to get Steeda clutch cables, lowering springs, Tri-ax shifters, x2 ball joints, control arms, cold air intakes, sway bars, bumpsteer kits, coilovers, and a variety of other performance parts.
Products by Vehicle
Upload a Picture
Upload your own picture of the Mustang Steeda Cold Air Intake Kit (2010) 4.6
Please make sure to hold your device horzonally (like a camera) rather than vertical (like a phone).
By uploading an image, you agree to give LatemodelRestoration.com permission to use it in future advertisements and promotions.
Testimonial: Fast, free shipping... need i say more?
This whole year (2013) i've ordered numerous parts. from the front end (core support, head lights, radiator) to a all new rear end ( gears, axles, control arms) and everything in between. very pleased with Latemodel restoration's fast, free shipping and prices. never had any issues with orders i just point,click, and two days later its at my doorstep. you can bet when it warms up, and i get some seat time, ill be back for parts reviews. GREAT JOB LMR! keep up the good work.
1983 Mustang G.T. I got it with a blown motor, and replaced the boat anchor it came with with a Mountaineer short block. G.T. 40P heads, a Comp cams XE270HR cam, Edelbrock intake and carb, headers, e...