Pypes Exhaust Systems are designed to deliver enhanced performance, provide extra punch in the passing lane and improve gas mileage on your 1996-04 V6 Mustang. Fabricated using the highest quality materials, our smooth, seam-coated, 16 gauge, mandrel-bent, stainless steel pipe ensures maximum exhaust gas flow, which can significantly boost horsepower. The stainless construction enables them to resist corrosion and extends the life of the system.
Pypes systems come complete with a pair of precision matched Pypes VIOLATOR mufflers(V8) or STREET PRO (V6), factory fit tailpipes, cad plated clamps and hangers. These systems can be installed at home without any special tools. Our easy to install, late model Mustang systems are designed to deliver that extra punch you’re looking for and will make sure that you get noticed.
- 16 gauge, mandrel-bent, stainless steel pipe
- Includes all hangers and plated hardware
- Slip-fit for ease of installation
- Installation instructions are included
- Includes turn down style stainless steel tips
- Includes Y-Pipe
- Shipping Specifications: 65 Lbs / 62” X 17” X 13”
This exhaust did the job on my old 1999 mustang. The old one needed to be replaced so I decided to go with a duel exhaust. It went on relatively easy in my garage, had to take the rear tires off to get the tail pipes over the rear axle. Had a few small issues, I was short one clip for the tailpipe mounts, I sure it was in the box but when the box was delivered it was very wet and the end was blown out of the box a little. The hardware box was smashed and parts were loose outside of their bag. Also the muffler boxes were wet and pretty beat up, the mufflers had a couple of good dents in them. All went together pretty well, but if you are going from single stock to duel here's a tip for you. The clips that are supplied for the hanger on the passenger side only one of them will fit. The clips are too short to reach the hole closest to the frame, the other one is fine. So what I did is remove the clip from the drivers side where the supposed clip will work and swap it, now use can use the longer clip on the passenger side. You will have to cut about 8" off the Y pipe to get it to fit. I find the whole thing not too bad if you take your time. I would recommend this to a friend as it's a very nice system for the money and also sounds awesome.
If you're working on a Latemodel Mustang, Pypes' innovative products, and superior quality allow you to make your exhaust purchase with absolute confidence that you are getting the best materials, best fit and best value available anywhere. Pype's aftermarket performance exhaust components give your Mustang more horsepower and torque while adding a great new exhaust tone. These x-pipes, h-pipes, headers, and cat back kits are direct fit and 100% bolt on, making installation quick and easy.
I've done the majority of my aftermarket mustang parts shopping at American muscle, recently finding out about this website I'd just like to say it is a great experience to shop here, the lay out is easy and simple to navigate, and you have thousands of parts that no other website has. The shipping is very fast and all te updates are great. I will be doin much more shopping with y'all, so thanks for being so badass haha
My 2004 Mustang
It has a 3-9, V-6 motor, BBK cold air induction, prediator chip, Ford 3.73 racing Gears, Lots of chrome under the hood,Has a Calif Tonneau cover over the rear seats to give it the roa...