Since the release of the 03-04 Terminator SVT Cobra, changing Mustangs (V6, GT, Bullitt and Mach 1) over to Cobra front ends has been a popular conversion. The 03-04 Cobra featured a unique front bumper cover, hood and fog light assembly. The fog light assemblies featured a fog light bezel that had a circular opening for a Fog Light and a brake cooling duct. If you want to convert your Mustang over to a 03-04 Cobra front end or if you just need to replace your worn-out Cobra fog lights, we have you covered with our full line of Cobra parts.
*** Note our fog lights are covered by our no hassle warranty ***
Fits Mustang SVT Cobra: 2003 (03) - 2004 (04)
Broken or damaged fog lights are very common on all year model Mustangs, such as the case on this '03 Cobra behind us. The previous owner decided they wanted to tint them black, did a very poor job of doing so. Now, they look completely like crap.
Luckily, for '03, '04 Cobra owners, we have everything you need to get your car looking as good as possible. Now, if you have a '99 to '04 V6 or GT and you've upgraded to a '03, '04 Cobra bumper cover, this kit applies to you as well, because we include the needed connectors and attaching hardware to attach your fog lights to the bumper cover.
Now, the fog lights include new bulbs, so you don't have to worry about purchasing those separately. And the install is really easy, can be done in your driveway in little to no time at all. Now, the bezels are side-specific and are marked on the back with an R or an L. Now, the R goes to the passenger side, L to the driver side.
Fog lights are universal. They'll go on either side. Now, to get started with the removal, unplug the electrical connector from the fog light bulb. Remove the four retaining screws that hold the fog light to the bumper cover. Then remove the two screws that hold the fog light bezel to the bumper cover.
Unsnap the bezel, and remove it from the car. Now, you can go back in with your new parts. Before I get this install finished up, check out just how bad off these original lights were. Installation is the exact opposite of removal. Go ahead and snap everything back together, and check for operation.
You could probably tell it that we have a huge improvement that just took place on this '03 Cobra. Now, for more Mustang lighting options, check out latemodelrestoration.com.
Whether you are looking for engine harness, fuel harnesses or just replacement oxygen sensor harnesses, 5.0Resto has you covered with a full selection of harnesses to ensure you don't spend all your time patching up a worn factory harness.
0:00:01 - 0:00:09 No matter what wiring project you have going on with your mustang, we have you covered with everything you need to get the job done right.
0:00:09 - 0:00:19 From complete engine conversion harnesses to factory correct restoration harnesses to the simplest of replacement connector pigtails, LatemodelRestoration.com has exactly what you need
My 2004 Mustang
It has a 3-9, V-6 motor, BBK cold air induction, prediator chip, Ford 3.73 racing Gears, Lots of chrome under the hood,Has a Calif Tonneau cover over the rear seats to give it the roa...