what is involved with the electronics to install, I see the TCM but would like to know what is required to hook up the electronics.
What type of shifter would be required,? Electric or Cable type, I assume this would need a trans cooler,
Asked by Karl M. from Independence | Comment 0 0
This transmission kit comes with a stand alone harness and computer that are pretty much plug and play. Basically 3 wires are not pre-terminated and will require you to find a source for them. One is a 12V power wire to power the system. next is a ground wire for the harness, and the 3rd wire is a Throttle position sensor lead that will have to tap into the TPS on your coyote engine. All of the steps are covered in the installation instructions. The shifter is a standard cable operated shifter so a factory shifter in a mustang will work just fine. As far as a transmission cooler goes, It is highly recommended to run an aftermarket transmission cooler on any performance based transmission application.
Answered by Scott G. from hewitt | Comment 0 0
Ford Mustang - 2011 (11) - 2012 (12) - 2013 (13) - 2014 (14)