This kit contains a 6 tooth drive gear and a 20 tooth driven gear, a driven gear retaining clip, and a drive gear retaining clip. This is the most accurate gear combination for a T5 car equipped with 4.30 gears.
When you change the rear end gears in your Mustang you will need to recalibrate your speedometer by installing a new speedometer gear. Our Mustang speedometer gears are inexpensive and only take a few minutes to replace! Check out our speedometer gear installation instructions for a full write up with pictures on how to change the speedometer gear in your Mustang.
Check out our YouTube channel for even more tech tips, installation videos, how-tos, and more. The best place to go for anything Mustang related!
Ford Motor Company Genuine Parts, Motorcraft® Parts and Ford and Motorcraft Remanufactured Parts are all excellent choices when it comes to performance, longevity and value for your Mustang or SVT Lightning. And they’re all backed by a Ford Motor Company limited parts warranty*, so you know their parts you use are going to perform like they should. Put the same parts on your Lighting & Mustang that came from the factory!
Upload your own picture of the Mustang Speedometer Gear Kit For T5 w. 4.30 Rear Gears (83-95)
Please make sure to hold your device horzonally (like a camera) rather than vertical (like a phone).
By uploading an image, you agree to give LatemodelRestoration.com permission to use it in future advertisements and promotions.
Testimonial: AMAZING SERVICE
I just gatta say i have ordered several things from interior kit to trim pieces to transmission and diff gears and install kit they are allways on the ball and helpfull over the phone both before and after the purchases....thank you for everything!!!!
I bought my Stang about 8 years, it has been sitting for about 3 years because it was stolen. When it was recovered it was missing a lot of interior parts, leaking oil, tranny problems, and electrical...